See the article on Configuring DHCP Services for more details. DHCP settings: If DHCP on this VLAN should be handled by the switch or forwarded to a server, make the appropriate selections.This IP address must exist in a subnet with a routed interface. Default gateway: The next hop for any traffic that isn't going to a directly connected subnet or over a static route.Multicast support: Enable multicast support if multicast routing between VLANs is required.VLAN: The VLAN this routed interface is on.This cannot be the same as the switch's management IP. Interface IP: The IP address this switch will use for layer 3 routing on this VLAN/subnet.Subnet: The network that this routed interface is on, in CIDR notation (ex.Interface name: A friendly name/description for the interface/VLAN.It is recommended that the uplink VLAN be configured first. The window that appears will allow the configuring of the first routed interface and a default route. Under Status > 元 routing status, click Configure layer 3 settings. To start using layer 3 routing, navigate to the switch details page by going to Switch > Monitor > Switches and clicking on the switch to be configured. Only VLANs with a routed interface configured will be able to route traffic locally on the switch, and only if clients/devices on the VLAN are configured to use the switch's routed interface IP address as their gateway or next hop. In order to route traffic between VLANs, routed interfaces must be configured.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |